POM-H (Delrin) or PEEK? The honest answer depends on four things: the load the part carries, the environment it lives in, the tolerance the drawing calls for, and the volume you are buying. Below is the comparison we use when we quote both options.
If you already know which one you need, send the drawing and we will confirm it. If you are not sure, the table below usually settles it in one pass.
Delrin vs PEEK: side-by-side comparison
| Dimension | POM-H (Delrin) | PEEK |
|---|---|---|
| Cost | Around 1/10 the price of PEEK | Very expensive per kg |
| Strength & performance | UTS 72 MPa, stiff and creep resistant | UTS 100 MPa, retains strength to 250 C |
| Corrosion / durability | Poor against strong acids | Excellent against most chemicals |
| Machinability & tolerance | Machines beautifully, holds tolerance | Machines well but needs annealing on thick sections |
| Lead time & tooling | 1-3 days, stock sizes common | 5-15 days, often made to order |
| Choose it when | Room-temperature mechanical parts at low cost | High temperature, chemical or implant service |
How to decide
- Start with the failure mode, not the price. If the part fails from corrosion, POM-H (Delrin) and PEEK are not interchangeable no matter what the price difference is.
- Check the tolerance the function actually needs. Tightening tolerance on a material that machines poorly multiplies the cost difference.
- Check availability. A cheaper material with a four-week lead time is more expensive than a dearer one that ships in a week.
- Check the finishing route. Plating and anodizing behave differently on each option and can change the decision on their own.
Where the cost difference comes from
Material price is only part of it. Machining time, tool wear, scrap rate and finishing cost usually decide the final number. A material that costs twice as much but machines three times faster can be cheaper per part. That is why we quote both options with the process route shown, not just a single price.
Frequently asked questions
Is POM-H (Delrin) better than PEEK?
Not in general. POM-H (Delrin) wins when room-temperature mechanical parts at low cost, and PEEK wins when high temperature, chemical or implant service. Give us the drawing and we will tell you which one we would choose and why.
How much more does POM-H (Delrin) cost than PEEK?
The material cost difference is only one input. Machining time and tool life matter as much. Send the part and we will quote both options side by side so the comparison is real.
Can you machine both POM-H (Delrin) and PEEK?
Yes. Both are routine for us, and we will say so if one of them is a poor fit for your geometry rather than quote it anyway.
Which one should I use for an export product?
Availability and documentation usually decide it. Both are widely stocked and certified, so the tie-breaker is normally the end user’s specification or the applicable standard.
Related pages
- Comparisons — the full index for this section.
- ABS vs Polycarbonate for Machined Enclosures
- Brass vs Copper: Machinability and Cost
- 17-4 PH vs 316 Stainless: Strength vs Corrosion
- Titanium vs Stainless Steel: Cost and Application
- Instant CNC quote
- Tolerance quick reference
- Frequently asked questions
Get a price for your part
Send a STEP file and a drawing with tolerances, material and quantity. We quote within one working day and machine in our own facility in Shenzhen — milling, turning, EDM, grinding and finishing under one roof, no trading middleman.
Start an instant quote or send your drawings directly. English-speaking engineering support, DFM feedback before you commit to a batch.